Phone line open 24/7 · Free to call Serving West Texas, the Panhandle & Central Texas
Texas › Waco heating repair
Waco & McLennan County

Heating & Furnace Repair in Waco, Texas

Waco usually sees mild winters, but cold snaps roll down the I-35 corridor quickly, and older homes near downtown and Baylor lose heat fast when the system quits. One free call connects you with an independent HVAC pro serving McLennan County.

  • Free to call
  • No obligation
  • Line open 24/7
  • Quote before any work

Free for homeownersNo fee to call or get matched

Phone line open 24/7Nights, weekends, freeze days

Independent local prosMatched to your service area

Quote before workYou decide — no obligation

What Waco homeowners are dealing with

Older Waco homes often have aging gas furnaces and leaky ductwork — no-heat calls frequently turn out to be failed igniters, dirty flame sensors, or airflow problems rather than a dead furnace.

Whether you're in Castle Heights, Sanger Heights, Woodway, or anywhere else in Central Texas, the independent contractors in our network handle:

  • Furnace not igniting or blowing cold air
  • Cracked heat exchanger inspection and replacement
  • Thermostat and igniter failures
  • Heat pump repair and emergency heat issues
  • Full system replacement quotes when repair no longer makes sense

Smell gas or hear a carbon monoxide alarm? Leave the house first, then call from outside. If Atmos Energy is your gas company, its 24-hour leak line is 866-322-8667; otherwise call your gas utility or 911. Don't run the furnace again until it's been inspected.

Common heating problems — quick guides

Furnace blowing cold air · Heat pump stuck on emergency heat · Furnace turns on then shuts off

What a service call looks like

  1. Call the number on this page. It's free and you're under no obligation.
  2. Describe the problem. You'll be matched with an independent contractor who serves Waco.
  3. Get a diagnostic visit. The contractor quotes the repair before any work starts — you decide.

Not sure what a fair price looks like? Read the Texas furnace repair cost guide before you call.

Check the contractor before work starts

Texas requires air conditioning and heating contractors to hold a license from the Texas Department of Licensing and Regulation (TDLR). Before you approve a repair:

  • Ask for the contractor's license number — Texas HVAC contractor licenses start with TACLA or TACLB.
  • Look it up on the TDLR license search to confirm it's active.
  • Get the diagnosis and price in writing before work begins, and ask whether the diagnostic fee is credited toward the repair.

Waco heating repair FAQ

Why does my older Waco furnace turn on and then shut off?

A dirty flame sensor is the most common cause — the furnace lights, can't confirm the flame, and shuts down for safety. Clogged filters and overheating can cause the same symptom.

Is a cracked heat exchanger dangerous?

It can be, because it may let combustion gases into the airflow. If a technician finds one, don't run the furnace until it's repaired or replaced, and make sure you have working CO detectors.

Repair or replace an old furnace?

On a furnace older than about 15–20 years, get a replacement quote alongside any major repair such as a heat exchanger or blower motor.

Get help in Waco today

Free call · No obligation · Independent local pros

Call (720) 719-5071
Call (720) 719-5071Free · No obligation · Open 24/7