Furnace blowing cold air? 7 causes and what to check
Cold air from the vents when the heat is on is one of the most common winter calls in Texas. Some causes take two minutes to fix yourself; others need a technician.
- Free to call
- No obligation
- Line open 24/7
- Quote before any work
Common causes
- Thermostat fan set to ON. With the fan on ON instead of AUTO, the blower runs even when the burners are off, pushing room-temperature air. Switch it to AUTO.
- Thermostat not calling for heat. Make sure it's set to HEAT, the setpoint is above room temperature, and the batteries are fresh.
- Clogged air filter. A dirty filter overheats the furnace, tripping a safety limit that shuts the burners off while the blower keeps running. Replace it and see if heat returns.
- Dirty flame sensor. The furnace lights, can't confirm the flame, and shuts the gas off. A technician can clean or replace the sensor — usually one of the cheaper heating repairs.
- Failed igniter. Hot-surface igniters crack and burn out, especially on the first cold nights of the season. No ignition means no heat.
- Clogged condensate line (high-efficiency furnaces). If the drain line or trap backs up, a safety switch stops the burners. Look for water around the furnace.
- Gas supply or leaky ducts. A closed gas valve, a gas service issue, or a disconnected duct in the attic can all mean cold air at the vents.
Smell gas or hear a carbon monoxide alarm? Leave the house first, then call from outside. If Atmos Energy is your gas company, its 24-hour leak line is 866-322-8667; otherwise call your gas utility or 911. Don't run the furnace again until it's been inspected.
When to call a pro
If you've checked the thermostat, filter, breaker, and furnace power switch and it still blows cold, it's time for a diagnostic. If you smell gas, leave the house and call your gas utility or 911 first.
Flame sensor service typically runs $80–$250 and igniter replacement $150–$400; see the full ranges in our furnace repair cost guide.
Check the contractor before work starts
Texas requires air conditioning and heating contractors to hold a license from the Texas Department of Licensing and Regulation (TDLR). Before you approve a repair:
- Ask for the contractor's license number — Texas HVAC contractor licenses start with TACLA or TACLB.
- Look it up on the TDLR license search to confirm it's active.
- Get the diagnosis and price in writing before work begins, and ask whether the diagnostic fee is credited toward the repair.
Find heating help in your city
Amarillo · Lubbock · Midland · Odessa · Abilene · San Angelo · Wichita Falls · Plainview · Canyon · Big Spring · Pampa · Temple · Killeen · Waco
More heating guides
Heat pump stuck on emergency heat · Furnace turns on then shuts off