Phone line open 24/7 · Free to call Serving West Texas, the Panhandle & Central Texas
Texas › Heating guides › Furnace turns on then shuts off
Heating troubleshooting

Furnace turns on, then shuts off? Causes of short-cycling

A furnace that lights and then shuts down after a few seconds or minutes — over and over — is short-cycling. It wears out parts, wastes gas, and can point to a safety problem.

  • Free to call
  • No obligation
  • Line open 24/7
  • Quote before any work

Common causes

  1. Dirty flame sensor. The most common cause: the burners light, the sensor can't confirm the flame, and the control board shuts the gas off for safety.
  2. Overheating from a clogged filter. Restricted airflow trips the high-limit switch. Replace the filter and make sure supply and return vents aren't blocked.
  3. Thermostat problems. A thermostat in a drafty spot, near a heat source, or with failing wiring can turn the system on and off too often.
  4. Blocked vent or flue. If exhaust can't vent properly, a pressure switch shuts the furnace down. This is a safety issue — have it inspected and make sure your CO detectors work.
  5. Oversized furnace. A furnace that's too big for the house heats it too fast and cycles constantly. A technician can tell you whether sizing is the issue.

Smell gas or hear a carbon monoxide alarm? Leave the house first, then call from outside. If Atmos Energy is your gas company, its 24-hour leak line is 866-322-8667; otherwise call your gas utility or 911. Don't run the furnace again until it's been inspected.

When to call a pro

Change the filter first. If short-cycling continues — or a CO alarm sounds — stop using the furnace and call for service.

Flame sensor cleaning or replacement typically runs $80–$250; thermostat replacement $120–$450. See the furnace repair cost guide for more.

Check the contractor before work starts

Texas requires air conditioning and heating contractors to hold a license from the Texas Department of Licensing and Regulation (TDLR). Before you approve a repair:

  • Ask for the contractor's license number — Texas HVAC contractor licenses start with TACLA or TACLB.
  • Look it up on the TDLR license search to confirm it's active.
  • Get the diagnosis and price in writing before work begins, and ask whether the diagnostic fee is credited toward the repair.

Find heating help in your city

Amarillo · Lubbock · Midland · Odessa · Abilene · San Angelo · Wichita Falls · Plainview · Canyon · Big Spring · Pampa · Temple · Killeen · Waco

More heating guides

Furnace blowing cold air · Heat pump stuck on emergency heat

Call (720) 719-5071Free · No obligation · Open 24/7